|
 Building Help --> Corkscrew Canyon
Video Building Tips:
General tips:
Page 13-Step 20 - The blue Rod cross snaps into bottom connection point on blue Connector that makes up this 3D connection. It is hard to see this because the view is blocked.
Page 25-Step 65 - When model is running if riders get stuck on ramp at this point, cross snap blue Rod into top rather than side connection point on blue Connector to elevate the slope of the ramp.
Page 38-Step 90 - Text does state that image is a top view and the letters are on the underside of the ramps. If you build it with the letters facing up the ramp will not fit into the model correctly.
Page 40-Step 93 - See enlarged section in bottom left corner of page. When model is running if riders get stuck on ramp at this point, remove the yellow Connector, black Rod, brown Connector and red Rod structure under this point so that ramp rests on edge of pool.
Page 80, Step 93 - The yellow Connector should attach to the E Ramp rather than the B Ramp as shown.
Motor - If you disengage the automatic ramp selection to use the manual selection and then return it to automatic selection again it may take 3 to 9 passes by the riders before the auto selection engages again. Be sure the wheel is pushed in fully in order for rgw auto select to work.
Need more help?
Browse the Help Center here on this web site, and if you don't find the information you need, send us your comment or question online, or call us at 1-800-KID-KNEX.
|
